... | ... | @@ -73,6 +73,7 @@ where also all results are stored. The general syntax of runOPAL.py is |
|
|
* *--block* runs opal local not using the batch system and waits until the job is done.
|
|
|
* *--keep* if same simulation has been run before, keep old data and abort.
|
|
|
* *--nobatch* uses plain mpirun on the local machine.
|
|
|
* *--optPilot will submit a optPilot job (check additional parameters that can be set in the *foo.data* file
|
|
|
* *ATTR* refers to a name in the data file
|
|
|
* *SCANVALUE* start\:end\:step, scans a parameter space, e.g., *TFWHM=0.85:0.90:0.01*.
|
|
|
|
... | ... | @@ -179,4 +180,4 @@ In this example instead of a restart step, a restart position is specified. |
|
|
`runOPAL.py --restart-file=/gpfs/homefelsim/adelmann/Phase3/FinPhase3/FinPhase3.h5 --restart-pos=10.0 ZSTOP=13.1`
|
|
|
|
|
|
|
|
|
If there exists no phase space dump at the specified position (10.0 meters here), the nearest position will be located and used. |
|
|
If there exists no phase space dump at the specified position (10.0 meters here), the nearest position will be located and used. |
|
|
\ No newline at end of file |