1. Geometry
At present the GEOMETRY
command is still an experimental feature
which is not to be used by the general user. It can only be used to
specify boundaries for the MG Solver. The command can be used in two
modes:
-
specify a H5Fed file holding the surface mesh of a complicated boundary geometry
-
specify a cylinder with an elliptic base area
1.1. Geometry Command
Command | Purpose |
---|---|
|
Specify a geometry |
|
Specifies the H5Fed geometry file |
|
Specifies the length of the geometry |
|
Specifies the start of the geometry |
|
Specifies the semi-major axis of the elliptic base area |
|
Specifies the semi-minor axis of the elliptic base area |
- FGEOM
-
Define the geometry file, an H5Fed file, containing the surface mesh of the geometry.
- LENGTH
-
The length of the specified geometry in [m].
- S
-
The start of the specified geometry in [m].
- A
-
The semi-major axis of the ellipse in [m].
- B
-
The semi-minor axis of the ellipse in [m].